Actonfire
Fire And Smoke Barrier
Traditionally the only product available for Fire Barrier applications, was a mineral fibre type, with installations often being difficult and cumbersome to achieve, especially in confined areas.
FIREFLY Fire barriers were developed to offer a flexible, lightweight, non-respirable, and easy to install product for all types of installations.
Typically the barrier is installed with the barriers fixed at the top with a support, and continuous galanvanised angle along the top, sides and bottom, screwed through at 250 centres.
A 100mm overlap should be left at all perimeters, and the stud and galvanised angle should be of a minimum gauge of 0.5mm. Heavier gauge metal can be used. This method creates a complete barrier to fire, smoke and when using the one of the insulated barriers, heat penetration
If there are penetrations through the barrier, please refer to the "Penetration Management" section.
Technical Data Sheet
